Avago-technologies Cache Protection for RAID Controller Cards Bedienungsanleitung PDF herunterladen (Seite 7)

Avago Technologies

- 7 -

LSICVM01 Kit Quick Installation Guide

September 2014

Installing the LSICVM01 Kit

3.3 Installing the Clip on the Remote Mount Board

Follow these steps to attach the clip to a BBU-BRACKET-05 remote mount board.

1. Make sure the remote mount board is on a flat, clean, static-free surface. Ground yourself, and make sure that the

system is grounded.

2. Remove the clip and the remote mount board module from the package.

3. Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.

4. Hold the clip so the screw holes on the clip line up with the screw holes on the remote mount board, as shown in

the following figure.

Figure 4 Installing the Clip on the Remote Mount Board

5. Secure the clip to three screw holes with the screws and the nuts.

The screws thread through the front of the clip and the remote mount board.

NOTE Center the screwdriver carefully to avoid stripping the screw heads. Do

not overtighten the screws.

Clip

3_00895b-00

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Avago-technologies Cache Protection for RAID Controller Cards Bedienungsanleitung Seite 7